CAT Error in "project single cube data"

[Catalina Torres]

Hello, community

I was hoping someone could help me fix this error (image below) that I get when I try to project CRISM I/F TRDR data. I already tried fixing the problem by following the instructions from https://pds-geosciences.wustl.edu/missions/mro/CAT_mapProjection_Fix.pdf but it didn't seemed to help. It might seem obvious for some, but I'm using ENVI 5.3 and CAT 7.4.

Any advice would be appreciated.

[Feng]

Hi Catalina,

I hope I can help you to fix the problem.

Recently we have updated the CAT map projection function due to an error happening on the new operation platform. I have several questions:

1, is your CAT package recently installed? If yes, maybe we can switch to the old package since you are using the old ENVI version. If not, did you see the error before when you use CAT?

2, If the above one doesn't fix the error, can you update ENVI to 5.6 or above?

We can set up a zoom session to troubleshoot this error if you like.

 

Thanks,

 

Feng

[Catalina Torres]

Hello Feng, first of all, thank you for your time and help.

Yes, I have recently installed CAT, so I'll try either switching CAT to it's older version or updating ENVI. Also no, this is the first time I see the error. Thanks a lot, I'll try first what you recommended and will let you know if a meeting is needed.

Again, thank you!